Canon imageCLASS MF7460 imageCLASS MF7400 Series Reference Guide - Page 130
Two-Sided Originals, Different Size Originals, Press [2-Sided Original].
View all Canon imageCLASS MF7460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Before Using the Machine 1 Original and Paper 2 Copying 3 Sending and Receiving 4 Printing and Scanning 5 Network (imageCLASS 6 MF7480/MF7470 Only) Remote UI (imageCLASS 7 MF7480/MF7470 Only) System Settings 8 Maintenance 9 Troubleshooting 10 Appendix 11 ˙ Two-Sided Originals You can set the machine to automatically turn over two-sided originals placed in the feeder, so as to scan each side separately. When you are scanning originals with a horizontal (landscape) orientation, such as LTRR, make sure to place them horizontally into the feeder. If these originals are placed vertically, the back sides of these originals are scanned upside down. 1. Press (SEND). 2. Place your originals. 3. Specify the destination. 4. Press [Scan Settings]. 5. Press [Option]. 6. Press [2-Sided Original]. 7. Select the type of original, then press [OK]. [Book Type]: The front and back sides of the original have the same top-bottom orientation. [Calendar Type]: The front and back sides of the original have opposite top-bottom orientations. 8. Press [OK]. Table of Contents Index Back Previous Next TOP 9. Press (Start). Scanning starts. The scanned data is sent to the specified destination when scanning is complete. - To cancel the scan settings, press [Scan Settings], then [Option], then [Cancel]. - To cancel all settings and return the machine to the Standard mode, press (Reset). ˙ Different Size Originals This mode enables you to scan different size originals together. - The Different Size Originals mode cannot be used with the Document Size or Stamp mode. - If the originals are placed in the feeder, make sure that the different size originals are of the same weight (paper type). - Align the top edge of the originals with the back edge of the feeder or the platen glass if you are placing originals with different widths. ("Width" refers to the vertical measurement of the paper from the front of the machine to the back of the machine when the paper is placed in the feeder or on the platen glass.) - Set different size originals in the following combinations. Other combinations may damage the originals. - 11" x 17" and LGL, LTR and LGL, LTR and LTRR - If you place originals with different widths into the feeder, the originals may move slightly when fed to the scanning area. As a result, the images may be scanned as slanted. - If the Different Size Originals mode is set, the scanning speed may be slower than normal. 1. Press (SEND). 2. Place your originals. 3. Specify the destination. 4-19