Canon imageCLASS MF7460 imageCLASS MF7400 Series Reference Guide - Page 474

Before Using the Machine 1 Original and Paper 2 Copying 3 Sending and Receiving 4 Printing and Scanning 5 Network (imageCLASS 6 MF7480/MF7470 Only) Remote UI (imageCLASS 7 MF7480/MF7470 Only) System Settings 8 Maintenance 9 Troubleshooting 10 Appendix 11 Table of Contents Index Rotary pulse A telephone dialing system where a dial is rotated to send pulses to the telephone switching system. In pulse dialing, you hear clicks. In touch-tone dialing, the most common dialing system, you hear tones. Rotary pulse dialing requires certain setting adjustments. RX See Receiving. S Scanning Area The area that is actually scanned is slightly smaller than the size of the original document, so words or images near the edges of the document may not be scanned. Therefore, you should allow some margin on all sides of the document that you are sending. Scope ID The Scope ID is a character string value that is appended to the NetBIOS name, and is used for all NetBIOS over TCP/IP communications. It provides a way for a computer to communicate only with others sharing the same Scope ID. Sending Sending documents is also defined as TX or Transmit. The machine can scan and send documents via fax, or e-mail, or send them to a file server. Sending speed The rate at which faxes are transmitted through the phone line. See also bps (bits per seconds). Sequential Broadcast See Broadcasting. SMB Server Message Block. A protocol that provides file and printer sharing over a network for Windows computers. SMTP Simple Mail Transfer Protocol. A TCP/IP protocol for sending messages from one computer to another on a network. Back Previous Next TOP SNMP Simple Network Management Protocol. The network management protocol of TCP/IP. In SNMP, agents, which can be hardware as well as software, monitor the activity of the various devices on the network and report to the network console workstation. Source Routing Normally, a host has no control over the route taken by a packet it sends. Source routing is a technique whereby the sender of a packet can specify the route that a packet should take through the network to its destination. Spool Simultaneous Peripheral Operations On-Line. Spooling means putting jobs in a buffer, which is a special area in memory or on a disk. Because devices access data at different rates, the buffer provides a waiting station where the data can wait until the device for which it is meant is ready to access it. Stamp Applies a stamp (about 1/8" (3 mm) in diameter) on the front side of originals after they have been scanned, so that you can distinguish already scanned originals from others. Standard Use this setting to send normal, typewritten, or printed documents containing only text and no drawings, photographs, or illustrations. See Fine, Super Fine, and Ultra Fine. Standby The mode in which the machine is on and ready to use. STP Shielded Twisted Pair cable. A cable consisting of one or more twisted pairs of wires and a sheath of foil and copper braid. The twists protect the wires from interference from each other, and the shielding protects the wires from interference from outside. Therefore, an STP cable can be used for high-speed transmissions over long distances. 11-91