Canon imageCLASS MF7460 imageCLASS MF7400 Series Reference Guide - Page 56

Before Using the Machine 1 Original and Paper 2 Copying 3 Sending and Receiving 4 Printing and Scanning 5 Network (imageCLASS 6 MF7480/MF7470 Only) Remote UI (imageCLASS 7 MF7480/MF7470 Only) System Settings 8 Maintenance 9 Troubleshooting 10 Appendix 11 Table of Contents Index - If you are placing the original on the platen glass, the size of the original is detected after the feeder is closed. Make sure to close the feeder before scanning. - Open the feeder and remove the original from the platen glass when scanning is complete. - The machine cannot detect the size of STMT and STMTR originals that are placed on the platen glass. After pressing (Start), follow the instructions on the screen to specify the original size. You can also manually select the paper size. Back Previous Next TOP ˙ Into the Feeder - If the same original is fed through the feeder repeatedly, the original may fold or become creased, and make feeding impossible. Limit repeated feeding to a maximum of 30 times (this number varies, depending on the type and quality of the original). - If the feeder rollers are dirty from scanning originals written in pencil, perform the feeder cleaning procedure. (See "Cleaning the Machine," on p. 9-2.) - Always smooth out any folds in your originals before placing them into the feeder. - Set the originals one by one if they are very thin (10 to 16 lb (37 to 52 g/m2)) or very thick (28 to 32 lb bond (105 to 128 g/m2)). - 11" x 17" and LGL originals must be placed horizontally in the feeder. 1. Adjust the slide guides to fit the size of your originals. 2-8