Canon imageCLASS MF7460 imageCLASS MF7400 Series Reference Guide - Page 54

Before Using the Machine 1 Original and Paper 2 Copying 3 Sending and Receiving 4 Printing and Scanning 5 Network (imageCLASS 6 MF7480/MF7470 Only) Remote UI (imageCLASS 7 MF7480/MF7470 Only) System Settings 8 Maintenance 9 Troubleshooting 10 Appendix 11 - If the top edge of the original is not aligned with the back edge of the platen glass (by the arrow in the top left corner), your original may not be scanned correctly, depending on the scan mode that you have set. - Originals of the following sizes can be placed either vertically or horizontally. However, the scanning speed for horizontally placed originals is somewhat slower than vertically placed ones. Place originals horizontally when scanning with a Preset Zoom, such as when enlarging an LTR original onto 11" x 17" paper. - Platen glass: LTR, STMT - Feeder: LTR - Horizontally placed LTR and STMT originals are referred to as LTRR and STMTR. - 11" x 17" and LGL originals must be placed horizontally on the feeder. Back Previous Next TOP ˙ On the Platen Glass The machine automatically detects the size of the following originals: 11" x 17", LGL, LTR, and LTRR. 1. Lift the feeder. This machine is equipped with an open/close sensor (A) on the feeder (see circled area in the above illustration). When placing originals on the platen glass, lift the feeder high enough so that the sensor does not touch the feeder. If the sensor continues to touch the feeder, the size of the originals may not be detected correctly. Table of Contents Index 2-6