Canon imageCLASS MF7460 imageCLASS MF7400 Series Reference Guide - Page 147
Stamping Originals, Press, SEND., Place your originals., Specify the destination.
View all Canon imageCLASS MF7460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
Before Using the Machine 1 Original and Paper 2 Copying 3 Sending and Receiving 4 Printing and Scanning 5 Network (imageCLASS 6 MF7480/MF7470 Only) Remote UI (imageCLASS 7 MF7480/MF7470 Only) System Settings 8 Maintenance 9 Troubleshooting 10 Appendix 11 Table of Contents Index ˙ Stamping Originals The feeder directly applies a stamp (about 3 mm in diameter) on the front side of originals after scanning them, so that you can distinguish already scanned originals from others. - The Stamp mode cannot be used with the Document Size or Different Size Originals mode. - The Stamp mode cannot be used when sending a fax document in the Direct Sending or Manual Sending mode. - You can also set the Stamp mode in Edit Standard Send Settings. (See "Standard Send Settings," on p. 4-40.) 1. Press (SEND). 2. Place your originals. 3. Specify the destination. For more information on specifying the destination, see "Specifying Destinations," on p. 4-21. 4. Press [Send Settings]. 5. Press [Stamp], then press [Done]. To cancel the Stamp mode, press [Stamp] again. 6. Press (Start). Scanning starts. A stamp mark appears on the original output. If the stamp is not marked clearly, see "Replacing the Stamp Cartridge," on p. 9-10. Back Previous Next TOP 4-36