HP Q7815A HP LaserJet P3005 - User Guide - Page 134
Non Hp Supply In Use, Mem Test Failure Replace Dimm 1
View all HP Q7815A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
Control panel message For help press MANUALLY FEED alternates with To continue press MANUALLY FEED alternates with To use another tray press MANUALLY FEED OUTPUT STACK alternates with Then press to print second sides MEM TEST FAILURE REPLACE DIMM 1 NON HP SUPPLY IN USE alternates with Ready NON HP SUPPLY INSTALLED alternates with For help pressFor help press PAPER PATH JAM FRONT DOOR alternates with For help press Paused alternates with To return to Ready press the STOP key Performing upgrade Performing... PAPER PATH TEST Description Recommended action Press for help. or See Load media for more information. Media is in tray 1, but the print job requires a Press specific type and size that is not currently available. or to print from the tray. Press for help. or See Load media for more information. No media is in tray 1, and a print job requires a specific type and size that is available in another tray. Press to print from another tray. See Load media for more information. or Press for help. The first side of a manual two-sided print job has been printed and the device is paused until for the output stack is reinserted. Take the printed stack out of the output bin and reinsert it in tray 1 to print the second side of the two-sided print job. Press to continue. See Print for more information. The memory DIMM has failed. Install a supported memory DIMM. See Install memory. The device has detected that a nonHP supply is currently installed but was pressed to override the message. If you believe you purchased an HP supply, go to www.hp.com/go/anticounterfeit. Service or repairs that are required as a result of using non-HP supplies are not covered under HP warranty. A new, non-HP supply has been installed. This message appears until an HP supply is installed or you press . If you believe you purchased an HP supply, go to www.hp.com/go/anticounterfeit. Service or repairs that are required as a result of using non-HP supplies are not covered under HP warranty. To continue printing, press . A page is jammed in the paper path. Open the front door and remove any jammed media. The device has paused. Press Stop to resume printing. A firmware upgrade is in process. No action necessary. Do not turn off the device. The device is performing a paper-path test. No action necessary. 122 Chapter 7 Problem solving ENWW