HP Q7815A HP LaserJet P3005 - User Guide - Page 65

1 2 1 Acceptable envelope construction 2 Unacceptable envelope construction Envelopes with adhesive strips or flaps Envelopes with a peel-off adhesive strip or with more than one flap that folds over to seal must use adhesives compatible with the heat and pressure in the product. The extra flaps and strips might cause wrinkling, creasing, or even jams and might even damage the fuser. Envelope margins The following gives typical address margins for a commercial #10 or DL envelope. Type of address Return address Delivery address Top margin 15 mm (0.6 in) 51 mm (2 in) Left margin 15 mm (0.6 in) 89 mm (3.5 in) NOTE For the best print quality, position margins no closer than 15 mm (0.6 in) from the edges of the envelope. Avoid printing over the area where the envelope seams meet. Envelope storage Proper storage of envelopes helps contribute to print quality. Envelopes should be stored flat. If air is trapped in an envelope, creating an air bubble, then the envelope might wrinkle during printing. Labels CAUTION To avoid damaging the device, use only labels recommended for laser printers. To prevent serious jams, always use tray 1 to print labels and always use the rear output bin. Never print on the same sheet of labels more than once or print on a partial sheet of labels. ENWW Media considerations 53