Icom IC-2820H Instruction Manual - Page 134
GPS-A SET MODE items - aprs
View all Icom IC-2820H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
14 MENU SCREEN OPERATION ■ GPS-A SET MODE items D Unproto address Sets up to 56-character unproto address. q Push [MAIN•BAND] to enter programming condition. wRotate [DIAL] to select the desired character. • Push [Aa](TONE•DTMF) to select the character group from capital letters or lower case letters. • Push [1/](M/CALL•MW) (Right band's) to select the character group from numbers or symbols. • Push [>](M/CALL•MW) (Left band's) or [
113
14
MENU SCREEN OPERATION
■
GPS-A SET MODE items
D
Unproto address
Sets up to 56-character unproto address.
q
Push
[MAIN•BAND]
to enter programming condition.
w
Rotate
[DIAL]
to select the desired character.
• Push
[Aa](TONE•DTMF)
to select the character group from cap-
ital letters or lower case letters.
• Push
[1/](M/CALL•MW)
(Right band’s) to select the character
group from numbers or symbols.
• Push
[>](M/CALL•MW)
(Left band’s) or
[<](V/MHz•SCAN)
(Left
band’s) to move the cursor right or left, respectively.
• Push
[CLR](DUP/MONI)
to clear the selected character.
• Push and hold
[CLR](DUP/MONI)
for 1 sec. to clear all charac-
ters after the selected character.
e
Repeat steps
w
until the desired address is programmed.
r
Push
[MAIN•BAND]
to set the programmed address.
t
Push
[BACK](V/MHz•SCAN)
(Right band’s)
to return to the
GPS-A set mode screen.
D
Data extension
Sets the data extension capability from “COURSE/SPEED”
and OFF
(default)
.
The transceiver’s course and speed information is addition-
ally transmitted with position data when “COURSE/SPEED”
is selected.
NOTE:
When “COURSE/SPEED” is selected, number of
character for “COMMENT” is limited to 36-character.
D
Time stamp
Selects transmitting time stamp type from DHM, HMS and
OFF. This function can be transmitted UTC
(Universal Time Co-
ordinated)
time only.
• OFF
: No time stamp is transmitted.
(default)
• DHM
: Time stamp in the format of Day, Hour and
Minute is transmitted.
• HMS
: Time stamp in the format of Hour, Minute and
Second is transmitted.
D
GPS-A symbol
Selects the desired GPS-A symbol.
Available symbols:
Ambulance, Bus, Fire Truck, Bicycle,
Yacht, Helicopter, Small Aircraft, Ship
(Power Boat), Car
(default)
, Motorcycle,
Balloon, Jeep, Recreational Vehicle,
Truck, Van, Other
If “Other” is selected, set the desired symbol code as follows;
q
Push
[MAIN•BAND]
to enter programming condition.
w
Rotate
[DIAL]
to select the 1st character from “\” and “/.”
e
Push
[>](M/CALL•MW)
(Left band’s)
to select the 2nd digit.
r
Rotate
[DIAL]
to select the 2nd digit character.
t
Push
[MAIN•BAND]
to program the symbol code.
When “Other” is selected, check the symbol codes of
APRS,
®
and set it correctly.