Icom IC-2820H Instruction Manual - Page 96

8 SCAN OPERATION ■ Scan start/stop D Preparation Scan resume condition (p. 78); program the scan edges (pgs. 76, 77); program 2 or more memory channels (pgs. 62, 63); set skip settings, if desired (p. 79). D Operation qSelect VFO mode for full/programmed scan with [V/MHz•SCAN]; or memory mode for memory scan with [M/CALL•MW] in the desired band (Left or Right). • Select the desired bank with the same band's [MAIN•BAND] for bank scan. w Push and hold the same band's [V/MHz•SCAN] for 1 sec. eRotate the same band's [DIAL] to select the scan type from ALL and programmed scan (PROG 0 to PROG 9), if VFO is selected in step q. rPush the same band's [V/MHz•SCAN] momentarily to start the scan. • To change the scanning direction, rotate the same band's [DIAL]. • The memory channel readout blinks the scan type as follows: • During full scan • During programmed scan tTo stop the scan, push the same band's [V/MHz•SCAN]. z Push [VFO/LOCK] to select VFO mode for SCAN 2 full/programmed scan; push [MR/CALL] to select memory mode for memory scan, in the main band. • Push [FUNC] then [MONI 1(BANK)] to select a bank for bank scan. x Push [SCAN 2(T-SCAN)]. c Push [Y] or [Z] to select the ALL and pro- grammed scan (PROG 0 to PROG 9), if VFO is se- lected in step z. v Push [SCAN 2(T-SCAN)] again to start the scan. • Push [Y] or [Z] for 1 sec. also starts the scan. b To stop the scan push [SCAN 2(T-SCAN)] or [CLR A(MW)]. • During memory scan • During bank scan Rotate [DIAL] to select "ALL" (full) or programmed scan (P1 to P9) in sequence. 75 Indicates scan edge channels. • P1 stands for 1A/1B Indicates bank initial.