Icom IC-2820H Instruction Manual - Page 97

SCAN OPERATION 8 ■ Scan edges programming 1 Scan edges can be programmed in the same manner as memory channels. Scan edges are programmed into scan edges, 0A/0B to 9A/9B, in memory channels. qSet the edge frequency of the desired frequency range in VFO mode: ➥ Set the frequency using the desired band's [DIAL]. ➥ Set other data (e.g. repeater settings, etc.) if desired. w Push the same band's [M/CALL•MW] for 1 sec. • "X" indicator and channel number blink. eRotate the same band's [DIAL] to select one of scan edge channel, 0A to 9A. rPush and hold [S.MW](M/CALL•MW) (Left band's) for 1 sec. 2 to program. 3 • 3 beeps sound and VFO is automatically selected. • Scan edge 0B to 9B is automatically selected when continuing to 4 push the [M/CALL•MW] after programming. tTo program a frequency for the other pair of scan edges, 5 0B to 9B, repeat steps q and r. 6 • If the same frequency is programmed into a pair of scan edges, programmed scan will not function. 7 8 9 10 [EXAMPLE]: Programming 145.300 MHz into scan edges 1A. 11 Push V/MHz SCAN to select VFO mode. Rotate AIN BA for setting frequency, etc. Push and hold M/CALL MW for 1 sec. 12 ND ND M M Rotate AIN BA " "Be"ep 13 14 " Beep " 15 S.MW ➠ M/CALL Push and hold MW (Left band's) for 1 sec. and continue to push 16 " " Beep " Beep "Beep 17 18 " Beep " 19 76