Icom IC-2820H Instruction Manual - Page 38

2 SETTING A FREQUENCY ■ Using the tuning dial q Rotate the desired band's [DIAL] to set the frequency. • If VFO mode is not selected, push the same band's [V/MHz•SCAN] to select VFO mode. • The frequency changes in the selected tuning steps. (p. 18) [DIAL] [V/MHz•SCAN] w To change the frequency in 1 MHz (10 MHz for some versions) steps, push [V/MHz•SCAN], then rotate [DIAL]. • Pushing and holding [V/MHz•SCAN] for 1 sec. starts scan func- tion. If scan starts, push [V/MHz•SCAN] again to cancel it. ■ Using the keypad The frequency can be directly set via numeral keys on the mi- crophone. z Push [BAND] to select the desired band (left or ENT right) as the main band. C • Push [VFO/LOCK] to select VFO mode, if necessary. x Push [ENT C(T-OFF)] to activate the keypad for digit input. c Push 6 keys to input a frequency. • When a digit is mistakenly input, push [ENT C(T-OFF)] to clear the input, then repeat input from the 1st digit. • Pushing [CLR A(MW)] clears input digits and retrieves the frequency. [EXAMPLE]: Setting frequency to 145.3625 MHz. Push While 1 MHz tuning step is selected, While 10 MHz tuning step is selected, the digit below 100kHz disappear. the digit below 1 MHz disappear. Push ■ Using the [Y]/[Z] keys ➥ Push [Y] or [Z] to select the desired frequency. YZ • Push [BAND] to select the desired band (left or right) as the main band in advance. • Pushing and holding [Y]/[Z] for 1 sec. activates a scan. If scan starts, push [Y]/[Z] or [CLR A(MW)] to cancel it. 17 Push Push