Asus PCI-DA2100 User Manual - Page 231

ASUS GUI RAID Manager: Installation 4Setting up a SCSI-to-SCSI controller using RS-232 1. Connect the RS-232 port of the SCSI-to-SCSI controller to a null modem using the appropriate RS-232 cable. Do the same to the serial interface of the local host. If your local host has more than one serial interface, write down the corresponding port number of the selected port (that is, COM1, COM2, etc.). 2. Configure the RS-232 serial communication port of the local host to correspond to that of the interface on the controller. You will only need to set the baud rate; the GUI RAID Manager automatically sets the other communications parameters. If you want to modify the baud rate setting on the controller, use the on-board console interface or the GUI RAID Manager. For information on the latter, see Chapter 4, Array Management. Your hardware should be set up as shown in the following figure: GUI RAID Manager Station SCSI-to-SCSI RAID Controller RS-232 Cable 2.2 Hardware Setup 2-5