Autodesk 663B1-05A111-1001 User Guide - Page 195

11 | Basics Tools Reference > Show Manipulator Tool Move Settings Discrete Move Lets you specify the amount an object is moved in increments (determined by the Step Size value). Relative Sets spacing relative to the current position while translating. That is, if the current position is 0.75, step size is 1 and Relative is on, you snap to 1.75, 2.75, and so on. If Relative is off and step size is 1, you snap to 1.00, 2.00, 3.00, and so on. Only selectable if Discrete Move is on. Step Size Specify the increment size. One unit is the default. (The scale of the unit (mm, cm, inches, feet, and so on) is dependent on your preferences.) Rotate Settings Snap Rotate Lets you specify the amount an object is rotated in increments (determined by the Step Size value). Relative Sets spacing relative to the current position while rotating. That is, if the current position is 10 degrees, step size is 15 degrees and Relative is on, you snap to 25, 40, 55, and so on. If Relative is off and step size is 15, you snap to 15, 30, 45, and so on. Only selectable if Snap Rotate is on. Step Size Specify the increment size. 15 degrees is the default. Scale Settings Discrete Scale Lets you specify the amount an object is scaled in increments (determined by the Step Size value). Relative Sets spacing relative to the current position while scaling. That is, if the current size is 1.25, step size is 1 and Relative is on, you scale to 2.25, 3.25, and so on. If Relative is off and step size is 1, you snap to 2.00, 3.00, 4.00, and so on. Only selectable if Discrete Scale is on. Step Size Specify the increment size. One unit is the default. (The scale of the unit (mm, cm, inches, feet, and so on) is dependent on your preferences.) Basics 195