Brother International HL-2400C Service Manual - Page 176

1.2.6 Cleaning the OPC Belt Cartridge The OPC belt cartridge should be cleaned according to the periodic maintenance cleaning cycle set out in Table 6-3. PRECAUTION • Do not directly touch the OPC belt surface with bare hands or gloves. • If the belt is exposed for more than two minutes to a light source of 800 lux, the belt may be damaged. 1) Cotton cloth (2 ∼ 3 pieces) 2) Cleaning brush (supplied with the printer) 1) Turn off the power supply. 2) Open the top cover and the front cover. 3) Release the belt cartridge lock levers to pull out the OPC belt cartridge. 4) Clean the OPC belt cartridge. i) Remove any toner on the corona wire with the brush supplied with the printer. (Fig.6-7) Cleaning brush location ii) Clean the OPC belt cartridge case with a cotton cloth. Corona Wire Fig.6-7 CAUTION • Be sure to dry the OPC belt cartridge completely when cleaning it with a damp cotton cloth. • Do not clean the OPC belt cartridge by using any solvents. VI-11