Brother International HL-2400C Service Manual - Page 491

CHAPTER 5 MAINTENANCE 7. Fit the metal parts and secure with the two screws. Fig. 5-21 Secure the Metal Parts  8. Release the pressure a little with the Pressure Release Levers( ).  Then pull the protective parts between the rollers of the Fusing Unit out to remove them( ).Make sure that the Pressure Release Levers are locked when the protective parts have been removed. Fig. 5-22 Removing the Protective Parts 9. Install the Fuser Cleaner and the Oil bottle into the new Fixing Unit and Lock the Oil Bottle Lock Levers. Be careful not to spill oil inside the printer. It might cause damage to the printer. 10. Press the Power button and turn the printer on. 11. Press the Sel button and make the printer Off Line. 12. Press the Reset button while holding down the Shift button. 13. When you see "RESET PRINTER" on the LCD panel, press the v (UP) or w (DOWN) button and select "RESET PARTS LIFE" . Press the Set button and select "FUSER UNIT" with the v (UP) or w (DOWN) button. 14. Press the Set button and the printer becomes On Line. ! Caution When you replace the Fusing Unit, do the replacement very carefully. Do not put pressure onto the Fusing unit. If you do, it might cause damage to the Fusing Unit and / or the printer. 5-19