Brother International HL-2400C Service Manual - Page 187

2.3 Transfer Roller Replacement The transfer roller should be replaced at the same time as a new discharger unit according to the periodical maintenance cycle set out in Table 6-4. When time is due for replacement of the transfer roller, the following message appears on the control panel. LJ READY 001P T1 REPLACE 120K KIT To prevent the transfer efficiency declining due to deterioration of the transfer roller. 1) Two or three pieces of cotton cloth for cleaning. 2) Transfer roller (one unit) Sequence of Disassembling 1) After turning off the printer, unplug the power cable from the power outlet. 2) Open the rear access cover. (Fig.618) Rear Access Cover Sequence of Replacement 1) Lift the transfer roller lock lever to release the right hand end of the roller. The angle of lifting the lock lever is approx. 80° from the horizontal. (Fig.6-19) Transfer Roller Fig.6-18 Lock lever VI-22 Fig.6-19