Brother International HL-2400C Service Manual - Page 503

CHAPTER 5 MAINTENANCE  Note Do not load B5 or smaller size paper and envelopes in the cassette which is loaded into the optional Lower Tray Unit. It might cause paper jams. Font Card, Flash Memory/HDD Card Installing a Font Card, Flash Memory Card and HDD Card This printer has two slots for an optional font cartridge and one slot for an optional font card, flash memory card or HDD card. (Type III HDD cards will only fit into card slot 2.) If you have installed optional font card(s), you can use the fonts stored in them as well as the resident fonts. For optional font cards, consult the dealer where you purchased the printer. If you have installed an optional flash memory card or HDD card, you can save macros and fonts on it. For flash memory card and HDD card operations and information, see "CARD OPERATION" in Chapter 4.  Notes  Do not install or remove cards with the printer power on, or you may lose all data from the card, or may seriously damage the card.  For more information about the cards, consult the dealer where you purchased the printer.  For the latest information: http://www.brother.com Follow these steps to install or remove a cartridge/card: 1. Make sure that the printer is turned off. If the printer is turned on, be sure to press the Sel button to set the printer off-line. If data remains in the printer memory, the Data LED stays on. Press the Form Feed button to print out the remaining data, then the Data LED goes off. Turn off the printer. 2. Insert an HDD card into slot 2 with the label facing to the right. It is not possible to fit a card into slot 1 with a Type III PCMCIA card fitted in slot 2. 3. Fit a flash memory or font card into either slot 1 or slot 2 with the label facing to the right. Make sure they are inserted correctly. To remove a card, pull it out of the slot with the printer turned off. 5-31