Brother International HL-2400C Service Manual - Page 248

2. OPERATOR CALL 2.1 Video Controller Mode The Ready LED is lit and an applicable message appears on the liquid crystal display (LCD) in the following cases; 1) Consumables require to be replenished. 2) Waste toner pack is full of waste toner. 3) Paper jam. 4) Periodic maintenance. 5) Maintenance work incomplete. The above cases are not regarded as a breakdown, and should be treated in accordance with Table 8-1; Table 8-1 Display Message CHECK XX TRAY Meaning No paper in the media cassette (XX is TRAY1 / TRAY2) 12 COVER OPEN FRONT The front cover is open Countermeasure Check the adjustment lever at the bottom of the upper media cassette and adjust to the correct setting when the CHECK TRAY1 message appears. Load a stack of paper into the cassette. Close the front cover. 12 COVER OPEN TOP The top cover is open. Close the top cover. 12 COVER OPEN REAR The rear access cover is open. Close the rear access cover. 13 JAM XXXXXX Paper jam in the printer. XXXXXX is DRUM / FEEDER / INSIDE / REAR. Remove the jammed paper from the indicated area. 14 NO CARTRIDGE XXXX COLOR No toner cartridge in the printer. Install the requested toner cartridge. XX NO CASSETTE 16 TONER EMPTY XXXX COLOR XX LOAD PAPER ***** SIZE No media cassette. XX is T1 / T2. Toner almost empty: Another 50 pages may be printed. (The Alarm LED is lit at the same time.) Incorrect size of paper in the media cassette XX. XX is T1 / T2. (The message appears alternately to show a particular size.) Install the requested media cassette. Remove the toner cartridge, rock it several times by 45°, and install it again or replace the toner cartridge with a new one. Load the requested size of paper in the media cassette and press the Form Feed button. VIII-3