Brother International HL-2400C Service Manual - Page 42

3. INSTALLATION WORK Install the unit parts of the starter kit into the printer according to the following procedures: 3.1 Install the OPC Belt Cartridge PRECAUTION • Do not directly touch the OPC belt surface with bare hands or gloves. • If the belt is exposed for more than two minutes to a light source of 800 lux, the belt may be damaged. 1) Open the front cover and the top cover by releasing the latches. CAUTION When installing or removing the OPC belt, be sure to open the front cover first. Failure to do so will cause the OPC belt to be damaged due to contact with the toner cartridges. Front Cover 2) Release the belt cartridge lock levers (left & right). Belt cartridge lock lever (Left) Top Cover Fig.3-3 Belt cartridge lock lever (Right) 3) Pull and remove the tension release pins on both sides (left & right) of the OPC belt cartridge. 4) Remove the protective sheet from the new OPC belt cartridge. Tension release pin Fig.3-4 OPC Belt Cartridge Protective sheet Tension release pin Fig.3-5 III-5