Brother International HL-2400C Service Manual - Page 431

CHAPTER 4 CONTROL PANEL  Notes When you send data to be saved on the card, it is temporarily stored in the RAM of the printer. Note the following:  If the received data exceeds the RAM capacity, a memory full error occurs. You can clear this error with the Continue button. When this error occurs, only part of the image has been stored in RAM, therefore, you cannot save the data to the card.  The printer is reset to ensure as much capacity as possible in RAM. If any data remains, it is printed out first. After you have finished sending data, press the Set button again, so that the printer exits from the data reception status. When you exit from the data reception status, select the data ID with the v or w button and press the Set button. The printer will then save the received data with the selected ID onto the card.  Notes  When you see an asterisk on the display, the ID number has been used for other data or a macro. If you select the used ID number, the old data or macro is erased and replaced with the new data.  Once the data is saved, you can execute it with "EXECUTE DATA" or with a data execution command.  The data saved in the SAVE DATA mode cannot be run with a macro execution command in HP PCL5C emulation. • Save Macro  Note The "SAVE MACRO" menu appears only in the HP PCL5C emulation mode. If you have downloaded a macro into the printer's memory, you can save the macro on the installed flash memory card or HDD card. If a macro has been downloaded into the printer's memory and you press the Set button at "SAVE MACRO," the printer prompts you to select the ID for the macro. Select the ID with the v or w button and press the Set button again, so that the printer saves the macro with the selected ID. 4-37