Brother International HL-2400C Service Manual - Page 317

6.6 Packing 1) Re-install the fusing unit into the printer. i) After setting the fusing unit in place, lightly press down the unit to firmly connect to the connector on the base. Fusing Unit ii) Tighten the securing screws while pressing down the fusing unit. Check the metal hook of the screw at the left hand secures the fusing unit correctly. iii) Close the rear access cover and top cover. 2) Check the following items are packed in the starter kit packing; Four toner cartridges (K, Y, M, C), OPC belt cartridge, Oil bottle, Fuser cleaner. (Refer to the figure as shown on the right.) OPC Belt Cartridge 3) Put the printer into the polyethylene bag. Oil Bottle Toner Cartridge 4) Pack the printer, the starter kit packing, the waste toner pack, and power cable in the carton using the original packing material. 5) Seal the outer carton firmly. Starter Kit Packing Fuser Cleaner Outer Carton Starter Kit Packing Waste Toner Pack Power Cable Printer A-15