Brother International HL-2400C Service Manual - Page 433

CHAPTER 4 CONTROL PANEL  Notes When you save the primary or secondary font, note the following:  The font is temporarily stored in the RAM of the printer before it is saved on the card. If the font data exceeds the RAM capacity, a memory full error occurs. You can clear this error with the Continue button. As not all the font data has been stored in RAM, you cannot save the font to the card. When the font data is saved, the printer is reset to ensure as much capacity as possible in RAM. If any data remains, it is printed out.  If you have saved the font at 600-dpi resolution and change the printer resolution to 300 dpi, the printer cannot print the saved font. • Download Font  Notes  The "DOWNLOAD FONT" menu appears only in the HP PCL5C emulation mode.  Be sure to print out the list of download fonts with the Test button and check the download font ID on the list before you enter this menu. You need to select the font in this menu using the same number you see on the list. If you have downloaded a font into the printer memory, you can save it on the flash memory card or HDD card. The printer prompts you to select the download font ID that you can find from the font list. Press the v or w button to move the cursor to the ID and select it with the Set button.  Note The download font IDs do not appear when fonts have not been downloaded. After you have selected the download font ID, press the Set button, so that the printer saves the selected download font. Vector or bitmapped fonts are saved in the format of the original font. Once you save the download font in the card, you do not need to download the font every time you need it. Since the flash memory card is in card slot 1 or 2 (the HDD card can only be used in card slot 2) of the printer, you can select the saved fonts as "CARD1(or 2) FONT" with the Font button or the font selection command from your software. For font selection, see "FONT Button" in Chapter 4. 4-39