Brother International HL-2400C Service Manual - Page 91

TS: TA: TPS: To maintain the temperature for fixing of the toner at 140°C by turning the thyristor on and off. Reference temperature ( °C) to identify that it is excessively hot inside the fusing unit. When it reaches this point ( °C), the relay RY turns off, the power supply to the heat lamp is shut down and the printer stops operating. Limit temperature when the thermal fuse will start to melt and shut down the power supply to the heat lamp if the temperature control circuit should break down. When the thermal fuse melts, the printer will stop operating. H0: When the THERR signal is input, the control panel indicates "H0", and the printer will stop operating. H2: If the temperature of the fixing unit does not reach the required point "T1" after a certain time, the control panel indicates "H2" and the printer will stop operating. H3: If the "Heater On" signal still continues after a certain time, the control panel indicates "H3", and the printer will stop operating. H4: If the temperature within the fusing unit becomes unusually hot and when ACOFF signal is input, the control panel indicates "H4", and the printer will stop operating. IV-42