Brother International HL-2400C Service Manual - Page 250

Display Message Meaning 31 PRINT OVERRUN Print overrun 32 BUFFER ERROR Input buffer overflow 34 MEMORY FULL Work memory overflow 40 LINE ERROR Error in the communications circuit 41 PRINT CHECK 42 CARD 1(2) FULL Error in communication with the engine controller Card overflow 43 CARD 1(2)W ERROR Card write error Countermeasure Press the Continue button to start printing the next page. Data which overran the print area on the page cannot be printed. Check your page protection setting with the Mode button. Setting page protection to the correct size could solve this problem. If printing at 600dpi, you may need to add optional SIMM memory. Press the Continue button to resume printing. Data lost in buffer overflow cannot be printed. Press the Continue button to resume printing. If the same error should occur after you press the Continue button, turn off the printer. Wait a few seconds, then turn it on again. Reduce the input buffer size. Turn off "KEEP PCL". Add SIMM memory with printer power off. Download font and the fonts saved in the HDD card might cause the error, for these occupy the same work area as the RAM. Memory expansion is recommended in that case. When the serial interface is used, check the communications parameters such as baud rate, code type, parity, and handshake protocols. When the parallel interface is used, check the interface cable communication. Turn off the printer. Wait a few seconds, then turn it on again. Delete unnecessary macros or fonts, or use a new card. Set the write protect button of the card to OFF if it has been set to ON. Use a new card. VIII-5