Brother International HL-2400C Service Manual - Page 658

PR99077 CAUTION Be sure to vacuum up waste toner remaining inside the plastic tube with a vacuum cleaner before removing the plastic tube. 4) Remove the set screw ST3x6 (2 pcs.) from the auger spring gear unit. 5) Take the auger spring out of the frame, then remove the auger spring gear unit from the printer inside . Auger spring gear unit Auger spring Fig.7-23b CAUTION When removing the auger spring gear unit, attach paper onto the transfer drum to prevent touching it. Note: • When removing the screws from the auger spring gear unit, use the screw driver whose shaft is long enough to reach the screws. If it is not available, remove the transfer drum before removing the screws. • When re-assembling the auger spring gear unit into the frame, fix the notch to the side frame and fix the boss into the hole of the base frame referring to the figure below;. Notch Auger spring gear unit Boss Fig.7-23c VII-16a