Brother International HL-2400C Service Manual - Page 38
Iii, Installation
View all Brother International HL-2400C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
CHAPTER III INSTALLATION 1. CONDITIONS REQUIRED FOR INSTALLATION Any Laser beam printer is likely to be influenced by the environment of the set-up location. If the printer is set-up in an inappropriate location, the printer may not perform as expected. Therefore, the following factors should be taken into consideration before deciding where to set-up the printer. 1.1. Environmental Conditions The printer should not be set up in the locations referred to in the following items (a) through (d) which specify inappropriate locations for set-up. (a) Where it is likely to receive direct sunlight or similar light. (For example, next to a window) (b) Where it is likely to suffer a big difference in temperature and humidity between the maximum and minimum levels. (Normal operation environment is within 10°C ∼ 32.5°C, 20 ∼ 80%RH and without any condensation.) (c) Where it is likely to be in a draft of cold air from an air-conditioner or warm air from a heater, or to receive direct radiant heat. (d) Where it is likely to be excessively dusty or be subject to corrosive gases such as ammonia. (e) Users should select a location with good ventilation and set the printer on a flat surface. (f) Users should check that the maximum angle of the set-up location is horizontal to within ±1°. 1.2. Basic Layout of Printer Set-up Location Fig.3-1 shows the basic layout of the printer set-up location that is suitable for smooth operation and maintenance of the printer. 10cm(4") 40cm(16") 70cm(28") Paper Exit Side Front Side 10cm(4") Fig.3-1 • The space in front of the printer (70cm) is necessary to open the front cover. • The space at back of the printer (40cm) is necessary to open / close the rear access cover. • The space on both sides of the printer (10cm) is necessary for general access. III-1