Cisco SR224T Administration Guide - Page 103

Port Management Configuring Link Aggregation 9 - 100 Full-100 Mbps speed and Full Duplex mode. - 1000 Full-1000 Mbps speed and Full Duplex mode. • Operational Advertisement-Displays the capabilities currently published to the port's neighbor. The possible options are those specified in the Administrative Advertisement field. • Neighbor Advertisement-Displays the capabilities advertised by the neighboring device (link partner). • Back Pressure-Select the Back Pressure mode on the port (used with Half Duplex mode) to slow down the packet reception speed when the switch is congested. It disables the remote port, preventing it from sending packets by jamming the signal. • Flow Control-Enable or disable 802.3x Flow Control, or enable the autonegotiation of Flow Control on the port (only when in Full Duplex mode). • MDI/MDIX-the Media Dependent Interface (MDI)/Media Dependent Interface with Crossover (MDIX) status on the port. The options are: - MDIX-Select to swap the port's transmit and receives pairs. - MDI-Select to connect this switch to a station by using a straight through cable. - Auto-Select to configure this switch to automatically detect the correct pinouts for the connection to another device. • Operational MDI/MDIX-Displays the current MDI/MDIX setting. STEP 6 Click Apply. The Port Settings are written to the Running Configuration file. Configuring Link Aggregation This section describes how to configure LAGs. It covers the following topics: Cisco Small Business 200 Series Smart Switch Administration Guide 104