Cisco SR224T Administration Guide - Page 196

Configuring Multicast Forwarding Adding MAC Group Address 15 Entries that were created both in this page and in the IP Multicast Group Address page are displayed. For those created in the IP Multicast Group Address page, the IP addresses are converted to MAC addresses. STEP 4 Click Add to add a static MAC Group Address. The Add MAC Group Address page opens. STEP 5 Enter the parameters. • VLAN ID-Defines the VLAN ID of the new Multicast group. • MAC Group Address-Defines the MAC address of the new Multicast group. STEP 6 Click Apply, the MAC Multicast group is written to the Running Configuration file. To configure and display the registration for the interfaces within the group, select an address, and click Details. The MAC Group Address Settings page opens. The page displays: • VLAN ID-The VLAN ID of the Multicast group. • MAC Group Address-The MAC address of the group. STEP 7 Select the port or LAG to be displayed from the Filter: Interface Type menu. STEP 8 Click Go to display the port or LAG membership. STEP 9 Select the way that each interface is associated with the Multicast group: • Static-Attaches the interface to the Multicast group as a static member. • Dynamic-Indicates that the interface was added to the Multicast group as a result of IGMP/MLD snooping. • Forbidden-Specifies that this port is not allowed to join this group on this VLAN. • None-Specifies that the port is not currently a member of this Multicast group on this VLAN. STEP 10 Click Apply, and the Running Configuration file is updated. NOTE Entries that were created in the IP Multicast Group Address page cannot be deleted in this page (even if they are selected). Cisco Small Business 200 Series Smart Switch Administration Guide 197