Cisco SR224T Administration Guide - Page 197

Configuring Multicast Forwarding Adding IP Multicast Group Addresses 15 Adding IP Multicast Group Addresses The IP Multicast Group Address page is similar to the MAC Group Address page except that Multicast groups are identified by IP addresses. The IP Multicast Group Address page enables querying and adding IP Multicast groups. To define and view IP Multicast groups: STEP 1 Click Multicast> IP Multicast Group Address. The IP Multicast Group Address page opens. The page displays all of the IP Multicast group addresses learned by snooping. STEP 2 Enter the parameters required for filtering. • VLAN ID equals to-Define the VLAN ID of the group to be displayed. • IP Version equals to-Select IPv6 or IPv4. • IP Multicast Group Address equals to-Define the IP address of the Multicast group to be displayed. This is only relevant when the Forwarding mode is (S,G). • Source IP Address equals to-Define the source IP address of the sending device. If mode is (S,G), enter the sender S. This together with the IP Group Address is the Multicast group ID (S,G) to be displayed. If mode is (*.G), enter an * to indicate that the Multicast group is only defined by destination. STEP 3 Click Go. The results are displayed in the lower block. When Bonjour and IGMP are enabled on switch in Layer 2 system mode, the IP Multicast address of Bonjour is displayed. STEP 4 Click Add to add a static IP Multicast Group Address. The Add IP Multicast Group Address page opens. STEP 5 Enter the parameters. • VLAN ID-Defines the VLAN ID of the group to be added. • IP Version-Select the IP address type. • IP Multicast Group Address-Define the IP address of the new Multicast group. Cisco Small Business 200 Series Smart Switch Administration Guide 198