Dell PowerEdge 4300 Dell PowerEdge 4300 Systems Installation and Troubleshooti - Page 136
Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide, ejectors 2
View all Dell PowerEdge 4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
To remove a DIMM, press down and outward on the ejectors on each end of the socket until the DIMM pops out of the socket (see Figure 8-7). ejectors (2) The microprocessor is contained within a single-edge contact (SEC) cartridge and heat sink assembly. The system board has two guide bracket assemblies that hold the SEC cartridge and heat sink assemblies. If your system has only one microprocessor, the unused guide-bracket assembly connector must contain a terminator card. If you are adding a microprocessor, it must have the same operating frequency as the installed microprocessor. For example, if the system has a 400-MHz microprocessor, the additional microprocessor must also be a 400-MHz microprocessor. 8-12 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide