Dell PowerEdge 4300 Dell PowerEdge 4300 Systems Installation and Troubleshooti - Page 137
Use the following procedure to install a terminator card in a guide bracket assembly
View all Dell PowerEdge 4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Use the following procedure, which is illustrated in Figure 8-8, to remove a terminator card from a guide bracket assembly: 1. Unsnap the retaining clip from the guide bracket assembly and remove the clip. Using the thumb and forefinger of each hand, pinch the vertical tabs at each end of the retaining clip and lift the clip straight up. 2. Slide the terminator card up and out of the guide bracket assembly. retaining clip terminator card guide bracket assembly socket tabs (2) notch Use the following procedure to install a terminator card in a guide bracket assembly: 1. Align the notch on the terminator card with the socket on the guide bracket assembly (see Figure 8-8), and guide the card into the empty guide bracket assembly. 2. Snap the retaining clip onto the guide bracket assembly on top of the terminator card. Installing System Board Options 8-13