Dell PowerEdge 4300 Dell PowerEdge 4300 Systems Installation and Troubleshooti - Page 157

See Installing Hard-Disk Drives in

Get Dell PowerEdge 4300 PDF manuals and user guides View all Dell PowerEdge 4300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 157 highlights

This chapter describes how to install and configure small computer system interface (SCSI) hard-disk drives in the computer's internal hard-disk drive bays. Instructions are also included for upgrading the system by installing a Dell host adapter card. The internal hard-disk drive bays provide space for up to six 1- or 1.6-inch hard-disk drives. (See Chapter 9, "Installing Drives in the External Bays," for information on installing SCSI CD-ROM drives, SCSI tape drives in the external drive bays.) NOTE: You may also install up to two 1-inch hard-disk drives in the external drive bay using an optional external drive bay assembly. See "Installing Hard-Disk Drives in the External Drive Bay" in Chapter 9 for more information. Figure 10-1 illustrates the internal hard-disk drive bays, the 1 x 6 hot-pluggable SCSI backplane board, and the Ultra2/low voltage differential (LVD) SCSI cable. The Ultra2/ LVD SCSI cable has two connectors: The connector at one end attaches to the Ultra2/LVD SCSI host adapter connector labeled "SCSI1" on the system board or to an optional SCSI host adapter card such as the Dell PowerEdge Expandable RAID Controller host adapter card. The connector at the other end of the cable attaches to the connector labeled "SCSI" on the SCSI backplane board. Installing Hard-Disk Drives 10-1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
Installing Hard-Disk Drives
10-1
&+$37(5²³¼
,QVWDOOLQJ±+DUG¶’LVN±’ULYHV
This chapter describes how to install and configure small computer system interface
(SCSI) hard-disk drives in the computer’s internal hard-disk drive bays. Instructions are
also included for upgrading the system by installing a Dell host adapter card
.
The internal hard-disk drive bays provide space for up to six 1- or 1.6-inch hard-disk
drives. (See Chapter 9, “Installing Drives in the External Bays,” for information on
installing SCSI CD-ROM drives, SCSI tape drives in the external drive bays.)
&$87,21±²%HIRUH²\RX²LQVWDOO²·³Á¶LQFK²KDUG¶GLVN²GULYHV²LQ²WKH²KDUG¶GLVN²
GULYH²ED\V´²WKH²FRPSXWHU²PXVW²KDYH²DW²OHDVW²WZR²SRZHU²VXSSOLHV²DQG²D²
SRZHU¶VXSSO\²SDUDOOHOLQJ²ERDUG²½363%¾²LQVWDOOHG³
NOTE: You may also install up to two 1-inch hard-disk drives in the external drive bay
using an optional external drive bay assembly
.
See “Installing Hard-Disk Drives in the
External Drive Bay” in Chapter 9 for more information.
Figure 10-1 illustrates the internal hard-disk drive bays, the 1 x 6 hot-pluggable SCSI
backplane board, and the Ultra2/low voltage differential (LVD) SCSI cable. The Ultra2/
LVD SCSI cable has two connectors:
²
The connector at one end attaches to the Ultra2/LVD SCSI host adapter connec-
tor labeled “SCSI1” on the system board or to an optional SCSI host adapter card
such as the Dell PowerEdge Expandable RAID Controller host adapter card.
²
The connector at the other end of the cable attaches to the connector labeled
“SCSI” on the SCSI backplane board.