Dell PowerEdge 4300 Dell PowerEdge 4300 Systems Installation and Troubleshooti - Page 146
the system power supply. The connectors on these cables are labeled P3, P4
View all Dell PowerEdge 4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
connector latches (2) interface connector on cable interface connector on the board Most interface connectors are keyed for correct insertion; that is, a notch or a raised tab on one connector matches a tab or a notch on the other connector. Keying ensures that the pin-1 wire in the cable (indicated by the colored strip along one edge of the cable) goes to the pin-1 ends of the connectors on both ends. Each drive in the external drive bays must connect to a four-wire DC power cable from the system power supply. The connectors on these cables are labeled "P3," "P4," "P5," and "P6." Connectors P3, P4, and P5 are used for 5.25-inch devices, whereas connector P6 is used for the standard 3.5-inch diskette drive. Before connecting a drive to a power cable, refer to Figure 9-5 to identify the correct cable connector to use for a particular drive. 5.25-inch drive connector 3.5-inch drive connector 9-4 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide