Dell PowerEdge 4300 Dell PowerEdge 4300 Systems Installation and Troubleshooti - Page 148
If the drive does not already have drive rails attached, attach a drive rail to each
View all Dell PowerEdge 4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
To install a SCSI device that uses the onboard Ultra/Narrow SCSI controller, follow these steps. 1. Prepare the drive for installation. Ground yourself by touching an unpainted metal surface on the back of the computer, unpack the drive, and compare the jumper and switch settings with those in the drive documentation. (See "SCSI Configuration Information" found earlier in this chapter for information on setting the drive's SCSI ID number and enabling termination, if required.) Change any settings necessary for this system's configuration. 2. If the drive does not already have drive rails attached, attach a drive rail to each side of the drive. Orient the drive rails as shown in Figure 9-6. Secure each drive rail to the drive with a screw in each of the lower slotted screw holes on the drive rail. drive-mounting rails (2) screws (6) screws (4) drive-release tabs (2) drive-release tabs (2) drive-mounting rails (2) 9-6 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide