Dell PowerEdge 4300 Dell PowerEdge 4300 Systems Installation and Troubleshooti - Page 79

The subtests in the Other test group and the functions they test follow. NOTE: Certain subtests are only available if an optional power-supply paralleling board {PSPB) is installed in the system. ESM Firmware Status Tests to make sure the ESM software was downloaded correctly and that the system is operational. ESM Interface Test Tests the interface between the host system and the ESM system to ensure that all bits in the data port function correctly. ESM System Board Sensor Check Lists the system alerts that have been recorded by the ESM system board sensors. The test reports which sensor caused the alert, the failure value, and the acceptable range the value exceeded. ESM Backplane Sensor Check Lists the system alerts that have been recorded by the ESM backplane sensors. The test reports which sensor caused the alert, the failure value, and the acceptable range the value exceeded. ESM PSPB Sensor Test Lists the system alerts that have been recorded by the ESM sensors on the optional PSPB. The test reports which sensor caused the alert, the failure value, and the acceptable range the value exceeded. ESM Intrusion State Test Reports whether the intrusion state sensor is functioning properly. ESM Front Panel LED Check Verifies the operation of the front-panel light-emitting diodes (LEDs) by turning all the LEDs on and off. ESM System Fan Test Modifies the revolutions per minute (rpm) of the system fans to verify the accuracy of the rpm reading. These are the most common symptoms that might prompt you to run the ESM subtests in the Other test group: The Dell OpenManage HIP server management application returns a warning dealing with server management. You want to verify that any component of the ESM system is working properly. Running the Dell Diagnostics 5-25