Epson FX-880 User Manual - Page 85
Make sure your paper has a clean, straight edge. Then open, the sprocket covers.
View all Epson FX-880 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
3. Release the sprockets by pulling the sprocket lock levers forward. 4. Slide the left sprocket approximately 12 mm (0.5 inch) from the far left position and push the lever back to lock it in place. Then slide the right sprocket to match the width of your paper, but do not lock it. Move the center support midway between the two sprocket units. 12 mm (0.5 inch) 5. Make sure your paper has a clean, straight edge. Then open the sprocket covers. Note: Make sure the printer is off before you insert the paper in the paper slot. If you insert the paper while it is on, a paper jam may occur. 3-24 Printing on Continuous Paper
3.
Release the sprockets by pulling the sprocket lock levers
forward.
4.
Slide the left sprocket approximately 12 mm (0.5 inch)
from the far left position and push the lever back to lock it
in place. Then slide the right sprocket to match the width of
your paper, but do not lock it. Move the center support
midway between the two sprocket units.
5.
Make sure your paper has a clean, straight edge. Then open
the sprocket covers.
Note:
Make sure the printer is off before you insert the paper in the paper
slot. If you insert the paper while it is on, a paper jam may occur.
12 mm (0.5 inch)
3-24
Printing on Continuous Paper