HP Latex 110 Users Guide - Page 152

A Summary of common printing problems This is a table of common problems and the parameters that can be changed in order to solve the problem. Some possible side-effects are also shown. For a more detailed treatment of any particular problem, please see the relevant chapter in this guide. Problem Durability problems, ink smudges, or oily finish Substrate jam, substrate damage, ink smears Parameter Curing temperature Number of passes Inter-path delay offset Curing temperature Vacuum Top and/or bottom margins Edge holders Vertical banding in saturated area fills Ink limits Inter-path delay offset Number of passes Group jobs together Modify the print queue Horizontal banding in saturated area fills Vertical banding in low-to-medium area fills Ink limits Inter-path delay offset Number of passes Modify color separations and dark color generation Align printheads Clean printheads Align printheads Ink limits Inter-path delay offset Vertical correction Take-up reel (accessory) Change Possible side-effects Increase Substrate jam, substrate damage, ink smears Increase Slower printing Increase Slower printing Decrease Less durability (smudges), oily finish Increase Substrate skew, vertical banding if increased too much Increase Waste of substrate Use The minimum side margins increase slightly, reducing the maximum width of the printed image Decrease Reduced color gamut Increase Slower printing Increase Slower printing Yes Avoids white space between prints Avoid printing difficult jobs (using a lot of ink) at the beginning of the queue Decrease Reduced color gamut Increase Slower printing Increase Slower printing Increase Increase Activate Use Slower printing Grainy aspect 146 Appendix A Summary of common printing problems ENWW