HP Latex 2700 User Guide 3 - Page 119
need to tap, to clear status errors.
![]() |
View all HP Latex 2700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
10. There is a strip of polyester film on the leading edge of the cleaning material. Insert it into the hole in the takeup core, which takes hold of it. 11. Slide the takeup core onto the lower axle. NOTE: If the cleaning roll has not been properly installed, you may see a message about clearing a printhead cleaning roll jam. Wind a little of the roll forward. The printer will check the roll again. You will need to tap Reinitialize to clear status errors. 112 Chapter 8 Handle the ink system
![](/manual_guide/products/hewlettpackard-latex-2700-user-guide-72cb20f/119.png)
10.
There is a strip of polyester film on the leading edge of the cleaning material. Insert it into the hole in the
takeup core, which takes hold of it.
11.
Slide the takeup core onto the lower axle.
NOTE:
If the cleaning roll has not been properly installed, you may see a message about clearing a
printhead cleaning roll jam. Wind a little of the roll forward. The printer will check the roll again. You will
need to tap
Reinitialize
to clear status errors.
112
Chapter 8
Handle the ink system