HP Latex 2700 User Guide 3 - Page 89

● A custom position is used for substrates thicker than 0.4 mm (0.016 in), or for substrates that wrinkle slightly due to heating. HP recommends setting the custom position as follows: - The thickness of the substrate plus 1.9 mm for substrates that do not wrinkle. - The thickness of the substrate plus 2 to 3 mm for substrates that wrinkle. You cannot exceed the maximum height permitted by the Internal Print Server. TIP: Try to avoid wrinkling by using substrates that do not wrinkle, or by using a slower print mode that will allow you to lower the drying and curing power. To set the carriage beam position, go to the Internal Print Server and select the appropriate position from the drop-down list. WARNING! Keep away from the printer's moving parts until the carriage beam has reached its new position. CAUTION: Do not change the carriage beam position while the printhead cleaning roll is out of place. 82 Chapter 7 Create and manage print jobs