HP Latex 2700 User Guide 3 - Page 164

7. Check whether the foams need to be replaced; if so, replace them. Store them in the ink collector container, keeping the latches on top. You can also store the edge holders there. 8. Perform the maintenance operations recommended after uninstalling the kit. Roll to free fall The roll-to-free-fall configuration is useful when you want to cut and remove one or more prints as soon as they come out of the printer. The substrate is kept under tension between the input roll and the tension roller; but it can be cut after the tension roller because then it is no longer under tension. The substrate roll is mounted on the input spindle; the printed substrate will be deposited on the floor in front of the printer. The substrate goes from the input spindle over the main roller, over the platen, over the front diverters, and then to the tension roller, after which it continues to the floor. You can load substrate with the printed face inwards or outwards on the spindle, in which cases the spindle will turn in opposite directions. The printer asks you for the winding direction if it cannot detect it automatically. Roll to collector The roll-to-collector configuration is useful when you may want to cut the substrate and remove the output roll before finishing a print job that uses a particular input roll. The substrate is kept under tension between the input roll and the tension roller; but it can be cut after the tension roller because then it is no longer under tension. This configuration is similar to the roll-to-free-fall configuration, but with the addition of a collector roller and tension bar. Roll to free fall 157