HP Latex 2700 User Guide 3 - Page 24

Power levels 1. Start in normal mode. The printer is on. 2. Switch to diagnostic mode. Mode used by the operator or the service engineer. At this level, you can perform maintenance and diagnostic operations, blocking high-voltage lines for safety when manipulating internal parts of the printer. 3. Switch to low power mode. Low power mode preserves the white ink channel. After restarting in low power mode, you should turn off the e-box switches. 4. Shut down. The printer is off. CAUTION: The white-ink printheads cannnot survive at this level for more than 4 hours. Move the printer If you wish to move the printer a short distance on the same site, across a horizontal floor with no steps and no slopes of more than 3% inclination, follow these instructions. For more difficult movement operations, contact your service representative. CAUTION: Slopes steeper than 3% may cause serious damage to the printer. 1. Turn off the printer. 2. Disconnect all power and network cables from the printer. 3. If the heavy-duty-roll accessory is installed, remove the anchor kit. 4. Raise the feet gradually, applying two turns each time to each foot so that the wheels (A) touch the ground. To raise a foot: a. Use a 24 mm (15/16 in) open-ended wrench to unlock the nut at the top of the foot. Move the printer 17