HP Latex 2700 User Guide 3 - Page 300

Problem due to overheating A printhead may overheat for several reasons: ● The room temperature may be too high. ● The printhead may be suffering from blocked nozzles. You may be able to cure this problem by cleaning the printheads (see Check and clean the printheads on page 96). ● The printhead may be faulty, in which case it should be replaced. Problem due to the primer system Primers are important to the printheads' nozzle health. When there is a problem with a primer, the Internal Print Server displays the following messages. ● A reseat message for a particular printhead ● A printhead replacement incomplete message ● A numerical error code starting with 0088 (for colour primers) or 1088 (for white primers): 0088-00XX-YYZZ or 1088-00XX-YYZZ ● A reseat message for a particular printhead ● A numerical error code starting with 0088 (for colour primers) or 1088 (for white primers): 0088-00XX-YYZZ or 1088-00XX-YYZZ The message 0088-0001-0Y41 - Primer 0Y leakage detected (or 1088-0001-0Y41 for white primers) indicates that one of the primer systems leaks. The number 0Y indicates which primer is leaking, where Y ranges from 1 to 6 for colour primers and from 1 to 2 for white primers. You are recommended to: ● Run the primer diagnostic test from the diagnostics window to confirm the cause of the error. ● Reseat the printhead. Make sure to push the primer into position before securing the latch. While running the test, you will already have done it at least once. ● Check that the O-rings in the primer ports are not broken or damaged. Replace the primer if any O-ring is missing or dented. Problem due to overheating 293