Lexmark X644E Service Manual - Page 108

7002-xxx User attendance messages-paper jams and paper handling errors (2xx.xx) Code Sub code Description Possible causes Action 202 .14 202 .15 202 .16 202 .17 202 .18 Exit sensor bounced. Fuser page count between 100,000 and 199,999. Exit sensor assembly. Go to "Fuser exit sensor service check" on page 2-138. Never sent the divert command to the stacker. Fuser page count between 100,000 and 199,999. Page is covering exit sensor during warm up. Fuser page count between 100,000 and 199,999. Something is keeping the exit sensor in a covered position. A page may not have been cleared from a prior jam. Check the fuser and area around the fuser assembly for any signs of debris or pieces of paper or media. Timeout waiting for the page ahead. Fuser page count between 100,000 and 199,999. Divert media command issued too soon. Fuser page count between 100,000 and 199,999. 202 .19 202 .20 Virtual page timed out waiting for the last page of the job to be safe in the stapler accumulator. Fuser page count between 100,000 and 199,999. Paper jam around fuser exit or redrive area. Fuser page count between 200,000 and 299,999. Paper may be jammed in fuser exit or redrive area. • Make sure the redrive door is complete closed. • Check the fuser for any signs of wear or contamination. If any are found, replace the fuser assembly. See "Fuser assembly removal" on page 4-79. • Turn media over to reduce +W curl. • Check upper redrive diverter and diverter spring for any signs of damage, a loose spring, or binding parts. Repair the redrive as necessary. • Check any installed output options(s) that may be installed for correct installation and alignment. • The fuser exit sensor may not be functioning properly. Go to "Fuser exit sensor service check" on page 2-138. 2-70 Service Manual