Lexmark X644E Service Manual - Page 244

7002-xxx Font Sharpening This setting allows a user to set a text point size below which the high frequency screens are used when printing font data. For example, at the default 24, all text in font sizes 24 and less will use the high frequency screens. The values for this setting range from 0 to 150, and the default value is 24. This setting affects PostScript, PCL, and XL. To change this setting: 1. Touch to select Font Sharpening from the Configuration Menu. 2. Touch to increase the value or to decrease the value. 3. Touch Back to cancel and return to the Configuration Menu. 4. Touch Submit to save the change. This function is not supported when the device generates output at 600 dpi resolution. Require Standby This setting determines if the Standby Mode is On or Off. The default is On. If Standby Mode is on, the printer begins functioning in Standby Mode when it remains idle for an amount of time. The Standby Mode enables the printer: • To consume less energy than when operating in normal mode but not as little as when operating in Power Saver • To return to the Ready state more quickly than when operating in Power Saver To change this setting: 1. Touch to select Require Standby from the Configuration Menu. 2. Touch Back to cancel and return to the Configuration Menu. 3. Touch Submit to save the change. LES Applications This disables all installed Lexmark Embedded Solution applications. The default is Enabled. To change this setting: 1. Touch to select LES Applications from the Configuration Menu. Note: If an advanced password has been established, you must enter this password in order to change the setting. If no advanced password exists, you can establish one by using the keyboard that appears on the LCD. 2. Touch Back to cancel and return to the Configuration Menu. 3. Touch Submit to save the change. 3-34 Service Manual