Lexmark X644E Service Manual - Page 85

7002-xxx User attendance messages (continued) Code Sub code Primary message Load [src] with [size] Load [src] with [type] [size] Reattach envelope feeder Reattach Bins x-y Description/action Occurs when a source is loaded with an incorrect print media size as specified in the Paper Menu. Touch Continue. Load the specified source that is set for the requested size. Touch Automatically select media to override manual requests for Manual Paper and Manual Env for the rest of the print job. All requests for additional pages are automatically overridden, and print media is selected from an automatic source. Touch Cancel Job to cancel the current job if needed. Touch Reset Active Bin to change to another linked bin. Occurs when the MFP requests that a specific media source be loaded with a specific type and size as specified in the Paper Menu, but the current source contains an incorrect media size and type. Touch Continue. Load the specified source that is set for the requested size and type. Touch Cancel Job to cancel the current job if needed. Touch Reset Active Bin to change to another linked bin. The MFP detects that the optional envelope feeder is missing between the time the job processes, and when it prints. Sometime during processing, the optional envelope feeder is removed. Touch Cancel Job to clear the message and continue without using the optional envelope feeder. Install the optional envelope feeder. Bins x-y=Bins 1 to 5, Bins 2 to 6, or Bins 6 to 10 This messages displays for the following conditions: • The specified output bins may have been removed from the printer, possibly to clear a paper jam or to remove the option. • The option(s) may be attached to the printer but a communications problem may prevent the printer from detecting the option. For example, there may be a poor connection or a hardware failure. The following actions may be taken: • If the option was temporarily removed or not connected properly, reattach or reconnect it. • Accept the configuration change which notifies the printer the option has been hot unplugged (removed with the power on). Note: This action is not available if the printer is in Diagnostics Mode or running diagnostics. • If the device is experiencing a hardware problem, turn the printer off and on. If the message continues to be displayed, go to "Input tray(s) service check" on page 2-147. Diagnostic information 2-47