Lexmark X644E Service Manual - Page 122

7002-xxx User attendance messages-paper jams and paper handling errors (2xx.xx) Code Sub code Description Possible causes 239 .03 239 .04 239 .05 239 .06 239 .07 239 .08 239 .11 241 .00 241 .04 241 .05 241 .06 Duplex did not send Device Controls response. • Mechanical feed error due to belt slipping. • Timing error due to feed system. Duplex did not send Input Device Ready response. • Mechanical feed error due to belt slipping. • Timing error due to feed system. Duplex did not send Page In Output Device response. • Mechanical feed error due to belt slipping. • Timing error due to feed system. Failed the last page of a staple job. • Mechanical feed error due to belt slipping. • Timing error due to feed system. Engine never sent Select OUtput Device to the duplex unit because the page leaving the duplex never sent Select Input Device. • Mechanical feed error due to belt slipping. • Timing error due to feed system. Engine never saw Input Source Read on a page to be picked from the duplex unit that is waiting on a page to pass the input sensor. • Mechanical feed error due to belt slipping. • Timing error due to feed system. Sheet picked from duplex never made it to the input sensor. Slow or delayed feed from the duplex unit. • Mechanical feed error due to belt slipping. • Timing error due to feed system. • Input sensor not working correctly. Paper jam near tray 1 Not applicable to tray 1 Not applicable to tray 1 Failed to pick from tray 1 Paper jam around autocompensator, faulty motor cable, faulty motor, autocompensator gear bind, failed controller card. 241 .07 241 .08 DC feed autocompensator stalled on a pick Paper jam around autocompensator, faulty motor cable, faulty motor, autocompensator gear bind, or failed controller card. Received lots of dc feed interrupts before losing them. Paper jam around autocompensator, faulty motor cable, faulty motor, autocompensator gear bind, or failed controller card. Action Replace the duplex option. Replace the duplex option. Replace the duplex option. Replace duplex option. Replace the duplex option. Replace the duplex option. Check duplex sensor cables for correct installation. If no problem is found with the cables, replace the duplex option. • Check for jam in tray. • Check for overloaded tray. • Check pick assembly and controller card. • Check for jam in tray. • Check pick assembly and controller card. • Check for jam in tray. • Check pick assembly and controller card. 2-84 Service Manual