Lexmark X644E Service Manual - Page 116

7002-xxx User attendance messages-paper jams and paper handling errors (2xx.xx) Code Sub code Description Possible causes Action 202 .54 202 .55 202 .56 202 .57 202 .58 Exit sensor may have bounced. Fuser page count stopped at 500,000 to preserve data. Exit sensor assembly. Go to "Fuser exit sensor service check" on page 2-138. Never sent the divert command to the stacker. Fuser page count more than 500,000. Page is covering the exit sensor during warm up.Fuser page count stopped at 500,000 to preserve data. Something is keeping the exit sensor in a covered position. A page may not have been cleared from a prior jam. Check the fuser and area around the fuser assembly for any signs of debris or pieces of paper or media. Timeout waiting for the page ahead. Fuser page count more than 500,000. Divert media command issued too soon. Fuser page count more than 500,000. 202 .59 202 .90 Virtual page timed out waiting for last page of job to be safe in the stapler accumulator. Fuser page count more than 500,000. Paper jam around the exit or redrive area. Fuser page count is not available. Page may be jammed in fuser exit or redrive area. • Make sure the redrive door is complete closed. • Check the fuser for any signs of wear or contamination. If any are found, replace the fuser assembly. See "Fuser assembly removal" on page 4-79. • Turn media over to reduce +W curl. • Check upper redrive diverter and diverter spring for any signs of damage, a loose spring, or binding parts. Repair the redrive as necessary. • Check any installed output options(s) that may be installed for correct installation and alignment. • The fuser exit sensor may not be functioning properly. Go to "Fuser exit sensor service check" on page 2-138. 2-78 Service Manual