Lexmark X644E Service Manual - Page 87

7002-xxx User attendance messages (continued) Code Sub code Primary message Description/action Replace all originals if restarting job. One or more messages which interrupted a scan job are now cleared. Replace the original documents in the scanner to restart the scan job. Touch Cancel Job if a scan job is processing when the attendance message appears. This cancels the job and clears the message. Touch Scan from Automatic Document Feeder if the page jam recovery is active. Scanning resumes from the ADF immediately after the last successfully scanned page. Touch Scan from flatbed if page jam recovery is active. Scanning resumes from the flatbed immediately after the last successfully scanned page. Touch Finish job without further scanning if page jam recovery is active. The job ends at the last successfully scanned page, but the job is not canceled. Successfully scanned pages go to their destination: copy, fax, email or FTP. Touch Restart job if job recovery is active and the job can be restarted. The message clears. A new scan job containing the same parameters as the previous job starts. Replace wiper The MFP detects that the fuser wiper needs replacing. 1. Replace the fuser wiper. 2. Touch Continue to clear the message. Touch Ignore to clear the message, but at the next power-on, the message appears again. Restore held jobs? Model X646e only. Held jobs are found on the hard disk after a power-on reset of the MFP. Touch Yes to restore the held jobs to the hard disk and make them available. The jobs data remains on the hard disk; however, the job control information is stored in the MFP memory. Touch Quit to stop restoring held jobs before all jobs are restored. Unrestored jobs remain on the hard disk and are retrievable again only at the next power-on reset. Note: A pop-up screen appears to indicate Restoring held jobs(s) xxx/yyy, where xxx indicates the number of the current job being restored, and yyy is the total number of jobs to be restored. Touch Do not restore to have the held jobs remain on the hard disk until they are deleted. Scan Document Too Long The scan job exceeds the maximum number of pages. Note: The scanner finishes scanning current pages in the ADF, but data is lost when the job cancels itself after reaching the maximum number of pages. Touch Continue to clear the message. Touch Cancel Job to clear the message if the job can be restarted. Touch Restart job if the job can be restarted. The message clears, and a new scan job containing the same parameters as the previous job starts. Scanner ADF Cover The scanner automatic document feed cover is open. Open The message clears when the cover is closed. Scanner Jam Access The scanner jam access cover is open. Cover Open Close the cover to clear the message. Scanner registration successfully completed Scanner registration is successful. Touch Continue to clear the message. Diagnostic information 2-49