Lexmark X644E Service Manual - Page 111
is covering the, during warm up. Fuser
UPC - 734646093156
View all Lexmark X644E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
7002-xxx User attendance messages-paper jams and paper handling errors (2xx.xx) Code Sub code Description Possible causes Action 202 .31 202 .32 202 .33 Page did not cleanly exit fuser or redrive area. Fuser page count between 300,000 and 399,999. Page may be jammed in fuser exit or redrive area. • Make sure the redrive door is complete closed. • Check the fuser for any signs of wear or contamination. If any are found, replace the fuser assembly. See "Fuser assembly removal" on page 4-79. • Turn media over to reduce +W curl. • Check upper redrive diverter and diverter spring for any signs of damage, a loose spring, or binding parts. Repair the redrive as necessary. • Check any installed output options(s) that may be installed for correct installation and alignment. • The fuser exit sensor may not be functioning properly. Go to "Fuser exit sensor service check" on page 2-138. Exit sensor covered too long. Fuser page count between 300,000 and 399,999. Page may be jammed in fuser exit or redrive area. • Make sure the redrive door is complete closed. • Check the fuser for any signs of wear or contamination. If any are found, replace the fuser assembly. See "Fuser assembly removal" on page 4-79. • Turn media over to reduce +W curl. • Check upper redrive diverter and diverter spring for any signs of damage, a loose spring, or binding parts. Repair the redrive as necessary. • Check any installed output options(s) that may be installed for correct installation and alignment. • The fuser exit sensor may not be functioning properly. Go to "Fuser exit sensor service check" on page 2-138. Page is covering the narrow media sensor during warm up. Fuser page count between 300,000 and 399,999. • If page is not visible from front or rear of the printer, a partial piece of a page may be torn off in the fuser covering the narrow media sensor. • The narrow media sensor or flag may be dislodged or damaged. Check the fuser and area around the fuser assembly for any signs of debris or pieces of paper or media. Diagnostic information 2-73