Lexmark X644E Service Manual - Page 112

7002-xxx User attendance messages-paper jams and paper handling errors (2xx.xx) Code Sub code Description Possible causes 202 .34 Exit sensor may have bounced. Fuser page count between 300,000 and 399,999. Exit sensor assembly. 202 .35 202 .36 Never sent the divert command to the stacker. Fuser page count between 300,000 and 399,999. Page is covering the exit sensor during warm up. Fuser page count between 300,000 and 399,999. Something is keeping the exit sensor covered. A page may not have been cleared from a prior jam. 202 .37 Timeout waiting for the page ahead. Fuser page count between 300,000 and 399,999. 202 .38 Divert media command issued too soon. Fuser page count between 300,000 and 399,999. 202 .39 Virtual page timed out waiting for last page of job to be safe in the stapler accumulator. Fuser page count between 300,000 and 399,999. 202 .40 Paper jam around the fuser exit or redrive area. Fuser page count between 400,000 and 499,999. Page may be jammed in fuser exit or redrive. Action Go to "Fuser exit sensor service check" on page 2-138. Check the fuser and area around the fuser assembly for any signs of debris or pieces of paper or media. • Make sure the redrive door is complete closed. • Check the fuser for any signs of wear or contamination. If any are found, replace the fuser assembly. See "Fuser assembly removal" on page 4-79. • Turn media over to reduce +W curl. • Check upper redrive diverter and diverter spring for any signs of damage, a loose spring, or binding parts. Repair the redrive as necessary. • Check any installed output options(s) that may be installed for correct installation and alignment. • The fuser exit sensor may not be functioning properly. Go to "Fuser exit sensor service check" on page 2-138. 2-74 Service Manual